« BACK TO INSTRUCTIONAL GUIDES

 

 

INSTALLING THE REAR RACK ON DISK BRAKE EQUIPPED FUSION OR CRUZ BIKES

 
1. Loosen seat clamp QR.
2. Install the adaptor T-bar as shown to the seat clamp.
 
3. Tighten QR so T-bar stays in place.
4. Select the adaptor plate hardware as shown.
 
5. Loctite the screws.
6. Install the plates as shown.
 
7. Install the rear luggage rack brackets on the inside of the adapter plates and include two small washers on the left (brake side) to widen the gap between the rack bracket and the brake nut.
 
A. Adjust brake to clear rack.
8. Completed install should look like this.
 
 
Please contact us at (620) 846-2209 with any questions about installation.
 
05/21/2013