V2 Formula 26 front fender installation varies because of the disc brake. The left side lower fender support will need to be attached to the top disc brake mounting bolt. (see photo #8) The support will need to be bent at a 45 degree angle perpendicular to mounting eyelet 1/2" away from eyelet. Now moving 3/4" back along the support toward the fender, bend the support again 46 degrees perpendicular to the eyelet. Now measure about 2" beyond the last bend and produce the same bends again so the support is now in the same plane as the eyelet. (See photo#10) After normal Fender attachment (see photo #9) on the right side and adjusting fender for symmetry then cut left side fender support off (see photo #11) and reattach the plastic tip guard