| 1. Attach front fender to frame using 6mm bolt (2) 6mm washers and 6mm nut. |
 |
| 1. Attach front fender to frame using 6mm bolt (2) 6mm washers and 6mm nut. |
|
| 2. Insert the fender support rods into the black mounts. Slip mounts onto the fenders and lightly tighten set screw. |
|
| 3. Attach the lower ends of support rods using 5mm x12 bolt and 5mm washer. Adjust the fender to the desired height and tighten set screw. |
|
| 4. Attach the back fender using the 6mm x 35 bolt (2) 6mm washers and 6mm nut. |
 |
| 5. Attach the four back fender support rods to the Aft dropout hole. Overlap the two support rods, then use 5mm x15 bolt and 5mm washer. Adjust the fender to desired height and tighten set screws. |
 |
